Announcement

Collapse
No announcement yet.

How to replace IP addresses in Plesk Panel?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • How to replace IP addresses in Plesk Panel?

    Hello,

    The utility reconfigurator.pl in plesk is used to replace IP addresses assigned to objects (domains/clients/resellers) in the Plesk Panel database and to reconfigure objects settings with the new IPs:

    # /usr/local/psa/bin/reconfigurator.pl

    Plesk reconfigurator - utility to change IP addresses used by
    Plesk Server Administrator

    usage:
    /usr/local/psa/bin/reconfigurator.pl <map_file>

    If <map_file> doesn't exists, a template will be created. Otherwise,
    it will be used to map IP addresses.


    Follow these steps to perform the IP addresses replacement:

    1. Make sure the new IP addresses are not registered in Plesk Panel on the Server > IP Addresses page. Otherwise, remove them from Plesk Panel before proceeding further.

    2. Run the utility to create the mapping template file:
    # /usr/local/psa/bin/reconfigurator.pl ipaddresses.map

    Then, edit this file and set the appropriate IP mapping. Map file matches in the full list of the currently configured IP addresses with the new ones in the following format:

    #cat ipaddresses.map
    eth0:192.168.50.60 255.255.255.0 -> eth0:192.168.50.60 255.255.255.0
    eth0:192.168.50.70 255.255.255.0 -> eth0:192.168.50.70 255.255.255.0

    Edit the file and replace an IP address in the right part of a string with one from the new set:
    eth0:192.168.50.60 255.255.255.0 -> eth0:new_ip_address 255.255.255.0

    3. Once the appropriate arrangement is given in the mapping file, run reconfigurator.pl again:
    # /usr/local/psa/bin/reconfigurator.pl ipaddresses.map

    It will read the mapping file and perform the replacement according to its content.

    Regards,

    Nelson S.
Working...
X